define MICROPY_HW_BOARD_NAME       "PCA10056"
#define MICROPY_HW_MCU_NAME         "NRF52840"
#define MICROPY_PY_SYS_PLATFORM     "nrf52840-PDK"

#define MICROPY_PY_MACHINE_UART     (1)
#define MICROPY_PY_MACHINE_HW_PWM   (1)
#define MICROPY_PY_MACHINE_RTCOUNTER (1)
#define MICROPY_PY_MACHINE_I2C      (1)
#define MICROPY_PY_MACHINE_ADC      (1)
#define MICROPY_PY_MACHINE_TEMP     (1)

#define MICROPY_HW_ENABLE_RNG       (1)

#define MICROPY_HW_ENABLE_USBDEV    (0)
#define MICROPY_HW_USB_CDC          (0)

#ifndef BLUETOOTH_CONF_H__
#define BLUETOOTH_CONF_H__

// SD specific configurations.

#ifndef MICROPY_PY_BLE_NUS
// Nordic UART Service
// If enabled, REPL will be available on this interface.
#define MICROPY_PY_BLE_NUS              (1)
#endif

#if (BLUETOOTH_SD == 110)

#define MICROPY_PY_BLE                  (1)
#define BLUETOOTH_WEBBLUETOOTH_REPL     (0)
#define MICROPY_PY_UBLUEPY              (1)
#define MICROPY_PY_UBLUEPY_PERIPHERAL   (1)

#elif (BLUETOOTH_SD == 132)

#define MICROPY_PY_BLE                  (1)
#define BLUETOOTH_WEBBLUETOOTH_REPL     (0)
#define MICROPY_PY_UBLUEPY              (1)
#define MICROPY_PY_UBLUEPY_PERIPHERAL   (1)
#define MICROPY_PY_UBLUEPY_CENTRAL      (1)

#elif (BLUETOOTH_SD == 140)

#define MICROPY_PY_BLE                  (1)
#define BLUETOOTH_WEBBLUETOOTH_REPL     (0)
#define MICROPY_PY_UBLUEPY              (1)
#define MICROPY_PY_UBLUEPY_PERIPHERAL   (1)
#define MICROPY_PY_UBLUEPY_CENTRAL      (1)

#else
#error "SD not supported"
#endif

// Default defines.

#ifndef MICROPY_PY_BLE
#define MICROPY_PY_BLE                  (0)
#endif

#endif

make BOARD=PCA10056 SD=s140 sd