Cortex M4F

• HydraBus 1.0 http://hydrabus.com/hydrabus-1-0-specifications
• Hardware doc, schematic/board are available on github: https://github.com/bvernoux/hydrabus/tree/master/hardware, Hardware licence CC BY NC (for commercial licence contact info@hydrabus.com).

###Features###

• Standard Dangerous Prototypes PCB size DP6037_v1 (see http://dangerousprototypes.com/docs/Sick_of_Beige_basic_case_v1) (very small 60mm x 37mm size).
• Programming firmware through USB DFU (without any debugger) with USB1 FS.
• Debug/Programming through low cost SWD Debug connector (can be programmed/debugged using a low cost STM32F4 Discovery board/NUCLEO for less than 20US$).
• Two MicroUSB port (1 OTG and 1 Device/Host) with ESD protection.
• MicroSD slot with 4bit SD and SDIO mode support in hardware (up to 48MHz about 24MB/s).
• Reset & User Button with User Led (can be disabled to reuse I/O for other stuff).
• Breakout of all 44 I/O (some are used by MicroSD and USB 1&2).
• HydraFW native open source firmware for HydraBus/HydraNFC with same syntax as BusPirate github: https://github.com/bvernoux/hydrafw
• HydraFW Wiki: https://github.com/bvernoux/hydrafw/wiki
• Micro Python firmware ported to HydraBus see HydraBus Micro Python github: https://github.com/bvernoux/hydrabus/tree/master/firmware/micropython and available in official branch https://github.com/micropython/micropython

###Status### Initial port completed with same feature as PyBoard with following exceptions:

• Only 1 LED is available (later update combined with HydraNFC Shield, 4 LEDs will be available).
• No accelerometer (but can be mounted on a breadboard or by doing a custom board see CC BY-SA 4.0 open hardware extension template for HydraBus: https://github.com/bvernoux/hydrabus/tree/master/hardware/HydraBus_1_0_Shield_Template_Rev0)

To build see https://github.com/bvernoux/hydrabus/tree/master/firmware/micropython.