Like GOES-East, of the six instruments on GOES-West used for observing the Earth and Sun, it is the "Advanced Baseline Imager" (ABI) instrument that provides visible and infrared views the earth. The ABI produces images at 16 different wavelengths (called bands and/or channels).
Note: During post-launch testing of GOES-West, an issue with a cooling system was discovered. The loop heat pipe subsystem, which transfers heat from the ABI electronics to the radiator for cooling, is not operating at its designed capacity.
The consequence of this is inadequate cooling for some of the infrared (IR) channels on the instrument during parts of the night, leading to partial loss of ABI imagery.
During nighttime hours, for part of the year, the sun shines onto the ABI detectors, which heat up faster than they can be cooled. The detectors become warmer than they're designed to operate, and as a result, emissions from the Earth overwhelm some infrared channels, meaning a useful signal is not available.
The individual channels are as follows:
Visible Bands
There are two visible bands, blue and red, named relative to their location on the visible portion of the electromagnetic spectrum.
While in their natural state, these images would appear in blue and red hues respectively, but colors have been desaturated to appear in grayscale. Since these are "visible" channels, the images will appear black at night.
Channel 1: The "Blue" band
The centralized wavelength for this band is 0.47 µm (micrometers).
Located in the blue portion of the visible spectrum, it provides nearly continuous daytime observations of dust, haze, smoke, and clouds. It also includes measurements of "aerosol optical depths" that help air quality monitoring and tracking. Measurements in the blue band may provide estimates of visibility as well.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 2: The "Red" band
The centralized wavelength for this band is 0.64 µm (micrometers).
The Red band is located near the red portion of the visible spectrum. While it looks similar to channel 1, when you want "visible imagery", this is the band to choose. It is used for daytime snow and ice cover, detection of severe weather, low-level cloud-drift winds, smoke, volcanic ash, hurricane analysis, and winter storm analysis.
This band is also the highest resolution band coming from GOES-16. Directly beneath the satellite (70°W, 0°N), the resolution is 1,600 feet (0.5 km).
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Near-Infrared Bands
Channel 3: The "Veggie" band
The centralized wavelength for this band is 0.86 µm (micrometers).
Although this is a "near-infrared" band (not visible to the eye), vegetation is readily seen at this wavelength, giving it the nickname "veggie" band. It is useful in assessing land characteristics when determining fire and flood potential. For example, forest fire damage will appear darker than nearby unaffected areas, which helps pinpoint locations where significant rainfall may lead to flooding and mudslides.
Water is very absorptive of this wavelength, which makes it appear dark in the image, resulting in a high contrast between land and water.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 4: The "Cirrus" bandLarger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 5: The "Snow/Ice" bandThe centralized wavelength for this band is 1.61 µm (micrometers).
This band takes advantage of the different way light is refracted between solid ice and liquid water. Snow and ice surfaces (solids) strongly absorb this wavelength. As a result, during daylight hours, ice crystals in snow and cirro-form clouds appear darker than clouds which consist of liquid water. During the nighttime hours, when it is too dark to distinguish snow/ice, very hot wildfires appear brightly against the dark background. Wildfires emit radiation at the same wavelength, so it is a dual-use band.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 6: The "Cloud Particle Size" bandThe centralized wavelength for this band is 2.24 µm (micrometers).
The cloud particle size increases as they change from liquid to ice. This channel helps maximize the apparent difference so we can distinguish liquid clouds from ice crystal clouds. Small particles (liquid) appear bright while larger ice crystals appear dark. Also, similar to the 1.6 µm band, the 2.2 µm band can be useful in determining hot spots at night. In fact, this channel is closer to the emitting energy of fires than channel 5.Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 7: The "Shortwave window"The centralized wavelength for this band is 3.9 µm (micrometers).
This infrared channel is sensitive to temperature and therefore able to see the slight thermal differences between the ground and low stratus clouds. This makes it useful for identifying night time fog and low clouds. It is also useful for detecting volcanic ash, estimating sea-surface temperatures, and studying urban heat islands.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Water Vapor Bands
The satellites do not directly detect moisture but instead detect temperature. Water vapor absorbs radiation at these particular frequencies, and thus the satellite does not sense much radiation when there is high water vapor. It records this as a low temperature, which is interpreted as high water vapor content. When radiation is not absorbed and thus received by the satellite, it senses a high temperature and consequently interprets a low amount of water vapor.
As a result, the depth at which the satellite peers into the atmosphere will vary with the amount of moisture over any particular point from day to day.
Channel 8: The "Upper-Level" Water Vapor band
The centralized wavelength for this band is 6.2 µm (micrometers).
The primary use for this band is the detection of upper level atmospheric features such as jet streams, troughs/ridges, and signs of potential turbulence.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 9: The "Mid-level" Water Vapor bandThe centralized wavelength for this band is 6.9 µm (micrometers).
Unless higher-level clouds obscure the view, this band can view as low as 500 mb level (about 18,000 feet/5,500 meters). It is used for mid- and upper-level water vapor tracking, jet stream identification, hurricane track forecasting, mid-latitude storm forecasting, severe weather analysis, and mid-level moisture estimation.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 10: The "Lower-level" Water Vapor band
The centralized wavelength for this band is 7.3 µm (micrometers).
This channel peers deepest into the atmosphere. Unless higher-level clouds obscure the view, this band can view as low as 750 mb level (about 8,000 feet/2,400 meters). As such, it is useful to view and estimate lower-level moisture and jet streaks (small areas embedded in the jet stream that can lead to severe weather). It can also be used to highlight volcanic plumes that are rich in sulfur dioxide (SO2).Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Infrared Bands
The following channels in the infrared range will appear to look similar. There are subtle differences between the channels, but their value comes from comparison with each other.
Channel 11: "Cloud-top" phase
The centralized wavelength for this band is 8.5 µm (micrometers).
Clouds can consist of the following phases: liquid water, super-cooled water (droplets remain in liquid form although the temperature is BELOW freezing), or frozen. This band is similar to the "traditional" infrared band (channel 14, below) but with the added benefit of helping to determine cloud phase. It is used in combination with channels 14 and 15 to help derive cloud phases during both day and night.With multiple ways to apply this data, this band is widely used in day to day operations. This band is essential for generating many products.Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 12: The "Ozone" bandThe centralized wavelength for this band is 9.6 µm (micrometers).
This band provides information about the dynamics of the atmosphere near the tropopause (the atmospheric boundary between the troposphere below – where we live – and the stratosphere above). The ozone band on the ABI does not give exact information on total ozone; rather, multiple ABI IR bands are used to calculate an estimate. The Total Ozone product provides information to forecasters that helps them forecast areas of atmospheric turbulence and provide better forecasts of air quality.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 13: The "Clean" Infrared band
The centralized wavelength for this band is 10.3 µm (micrometers).
This channel is considered "clean" because it is less sensitive than other infrared window channels to water vapor. Because of this, when compared to channel 11, it can see through some clouds to view ice. This helps to improve corrections to atmospheric moisture and is useful for the estimation of cloud particle sizes. Channel 13 will be used in many composite and band differences views.Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 14: The "Traditional" Infrared bandThe centralized wavelength for this band is 11.2 µm (micrometers).
Observations from this infrared window channel combined with other wavelengths, contribute to many satellite derived products, such as precipitation estimates, cloud-drift winds, hurricane intensity and track analyses, cloud-top heights, and volcanic ash detection, as well as fog detection, cloud phase, and cloud particle size estimates.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 15: The "Dirty" Infrared bandThe centralized wavelength for this band is 12.3 µm (micrometers).
This channel is considered "dirty" because it is more sensitive than other infrared window channels to water vapor. When compared to the "clean" window (channel 13) it is used to compute the split window difference. A split window difference is where the values for any particular location on the "dirty" channel are subtracted from the values at the same location on the "clean" channel. This helps to highlight differences in moisture in clear skies.Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
Channel 16: The "Carbon Dioxide" bandThe centralized wavelength for this band is 13.3 µm (micrometers).
This band is typically not used for visual interpretation of weather events but for the generation of other derived GOES imagery. Its primary use is for air temperature estimation, determining the location of the tropopause and cloud observations for cloud top height, cloud-drift (for determining wind speed and direction), and supplementing ASOS observations.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops
True ColorThis image is not a single channel but a combination of several GOES-R channels along with a polar orbiting satellite. During daytime, bands 1, 2 and 3 (red, blue and "veggie") are combined to produce an approximation of how it would appear if viewed with human eyes from space.
At night, bands 7 and 13 are combined and colorized. The nighttime blue colors represent liquid water clouds such as fog and stratus, while gray to white indicate higher ice clouds. Finally, from a polar orbiting NASA satellite, the nighttime city lights are added.
Larger sizes: 2500 x 1500px | 5000 x 3000px | Additional views and loops